| ![](/p.gif) |
![](/p.gif) |
| Item number: CIEN9-5884386 Manufacturer no.: 527139 EAN/GTIN: n/a |
| |
|
| ![](/p.gif) | ![](/p.gif) |
![](/p.gif) | Use an active holder for your iPad while driving and you will always have a freshly charged battery! The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the iPad into place in the holder, and to take it with you when leaving the car. Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations. An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder Carefully, slide the device sideways into the holder so you hear/feel it snaps into place. To remove the device from the holder: Slide it to the left then press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder. 4. The holder is in place in upright, horizontal position. More information: Power | DC voltage range | 12 V | Design | Mobile device type | Handheld mobile computer | ![](/p.gif) | Product colour | Black | ![](/p.gif) | Type | Active holder | ![](/p.gif) | Material | Plastic | ![](/p.gif) | Compatibility | Ipad |
|
| ![](/p.gif) | ![](/p.gif) |
![](/p.gif) | | ![](/p.gif) | ![](/p.gif) |
![](/p.gif) | Other search terms: Mobile phone holders & mounts, Mobile phone mount, Mobile phone mounting brackets, Mobile phone mount holder, Mobile phone holder support, Mobile phone holder, Mobile phone holders, Smartphone holder, Smartphone holders, Vehicle battery charger, Vehicle battery chargers, Car charger, Car chargers, Car battery charger, Car phone holder, Car phone holders, Car phone mount, Car phone mounts, Car smartphone holder, Car smartphone holders, Cable holder, Cable management, Notebook power supply, Laptop power supply, Notebook charger, Notebook chargers, Laptop charger, Laptop chargers, Power supply notebook, Power supply laptop, Tablet PC holder, Tablet PC holders, Tablet PC mount, Tablet PC mounts, Tablet stand, Tablet stands, Tablet holder, Tablet holders, Tablet mount, Tablet mounts, iPad accessories, ipad accessories charger, car phone holder, telephone holder, phone holders, phone holder, device holder, mobile device holder |
| ![](/p.gif) | ![](/p.gif) |
| |