Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Console mount Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Due to the narrow seam/gap in the console sidewall there is a two step operation to get the gap openers in place:
See narrow part of picture: Press the thin end of the enclosed gap opener into the gap between the center console edge and the sidewall edge, to widen the gap.
See large part of picture: Press the second gap opener into the gap to the left of the first gap opener. Then pull out the first gap opener and press it into the gap to the left of the second gap opener.

2. Peel off the cover of the adhesive tape on the ProClip. Place the angled edge on the left side of the ProClip over the console edge.

3. Place your index fingers behind the ProClip. Pull so the ProClip flexes towards you, and hook the angled left edge into the gap between the gap openers. Then press firmly towards the right side of the ProClip to make sure the angled edge is all the way into the gap. Pull out the gap openers.

4. The ProClip is in place.