Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention: Please read all of the instructions and look at the pictures before attaching the ProClip.
This ProClip is divided into two parts, which will be referred to as Part 1, and Part 2:
Part 1: The attaching part (the smallest part)
Part 2: The ProClip faceplate

1. Peel off the cover of the adhesive tape on Part 1 and place the thin angled edge into the gap between the center console panel and the console edge.

2. Press the angled edge firmly into the gap and at the same time: bend Part 1 to the right until you hear/feel it snaps into place and the adhesive tape attaches to the console edge.

3. Press a screwdriver (Philips) firmly through the predrilled holes in Part 2 to open them up. Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes in Part 2 match the holes in Part 1, and the adhesive tape on Part 2 is on the left side attaching to the center console panel. Screw Part 2 onto Part 1 using the enclosed screws.

4. The ProClip is in place.