The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention! Read all instructions before attaching the ProClip.
Part 1. Attaching piece.
Part 2. ProClip face plate.
1. Remove the frame surrounding the stereo.
2. Loosen the two screws that are the furthest in in the control panel.
3. Press the thin end of the enclosed gap opener into the gap between the dashboard and the frame surrounding the control panel to widen the gap. Peel off the cover of the adhesive on Part 1. Press Part 1 into the gap above the gap opener, next to the stereo. Slide Part 1 downwards in the gap. Press to the right on Part 1, away from the steering wheel, so the angled edge hooks behind/under the panel frame and the adhesive tape sticks.
4. Press a screwdriver (Philips) through the predrilled holes in Part 2. Peel off the cover of the adhesive. Place Part 2 onto Part 1 so the holes match. Screw Part 2 onto Part 1 using the enclosed screws. Pull out the gap opener. Tighten the screws. Put back the frame. The ProClip is in place.
|
