Sub-Part Clamps/Sub-Part Stop | 23211.0020

The sub-part clamp and the sub-part stop enable workpieces to be clamped on the front face. This allows the full area of the machine table to be used to clamp the workpiece.

• Hold-down effect due to inclined arrangement of the clamping jaw
• Clamping of large workpieces on the whole of the machine table
• Large clamping forces up to 20 kN
• Clamping path 10.6 mm by means of clamping screw M 16 (WS 14)
• Solid version made of vibration-eliminating ductile iron
• Optimum adaptation to the workpiece and material, through the use of clamping inserts and interchangeable jaws
• Form and forced-fit assembly in a T-slot is possible
• Minimum interference contours, even for large workpieces
• Location holes at the sides for fastening of longitudinal stops