Mounting Kits (4,527 items)

V-slot button and clip holder. With predrilled holes. Big. Used for mobilephone, pager and orther products with button or a clip-holder. Predrilled for mount on a ProClip.

Vertical Mounting plate (155x50x5mm). The extension plate makes it possible to attach two devices with tilt swivel onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder. ...

Plate with predrilled AMPS holes. 14x42x50 mm.

Used for positioning the installed equipment further away from the dashboard.

Note-pad holder with tilt swivel. Note-pad and pen included. Holder for note pad, with tilt swivel. Attach onto ProClip Mounting Platform. Note pad and pen included. Attention! Read all instruction...

Extension plate, 143x50x5mm. With predrilled AMPS holes. The extension plate makes it possible to attach two devices onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder...

The extension plate makes it possible to attach to units onto the same ProClip, e.g. a PDA holder as well as a mobile phone holder. Comes with screws and adhesive tape on the back. With predrilled ...

MoveClip for Tilt swivel, with predrilled holes. 1 female + 1 male + 2 screws. 50 x 42 x 5 mm. The Move Clip system is basically a female plate with a wide V-slot and a male plate that is shaped to...

Female cigg-plug with open ends for fixed installation. Cigarette lighter socket with open ends for fixed installation. Is to be used when you want to use an active holder with cigarette lighter pl...

Vertical Mounting plate (155x50x5mm). The extension plate makes it possible to attach two devices onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder. With predrilled h...

Self tapping screws for ABS plastic, used when making own special mounting solutions.

Mounting plate (80x50x5mm). AMPS-standard. The choise when you want to install your device positioned a bit to the left or right than the center of the ProClip. Predrilled holes, AMPS standard. Mad...

Mounting plate, with tilt swivel. Attention! Read all instructions before attaching the holder. 1. Loosen the screw in the center of the holder so you can remove the attaching part on the back. 2. ...

A small, oval face plate with predrilled holes for Nokia and Sony Ericsson Original HF-kits, Brodit holders and THB HF-kits. Can be angled 15° in every direction.

Flexible arm, 15 cm. With predrilled AMPS-standard holes. A flexible arm with AMPS plates in both ends. For installation of monitors, printers and other heavier devices in busses, trucks etc. Is to...