Mounting Kits (4,527 items)

Female cigg-plug with open ends for fixed installation. Cigarette lighter socket with open ends for fixed installation. Is to be used when you want to use an active holder with cigarette lighter pl...

Vertical Mounting plate (155x50x5mm). The extension plate makes it possible to attach two devices onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder. With predrilled h...

A small, oval face plate with predrilled holes for Nokia and Sony Ericsson Original HF-kits, Brodit holders and THB HF-kits. Can be angled 15° in every direction.

The extension plate makes it possible to attach to units onto the same ProClip, e.g. a PDA holder as well as a mobile phone holder. Comes with screws, Size: 100x50x5mm

Used for mobilephone, pager and orther products with button or a clip-holder. Predrilled for mount on a ProClip.

Note-pad holder with tilt swivel. Holder for note pad, with tilt swivel. Attach onto ProClip Mounting Platform. (Note pad and pen are not included.) Attention! Read all instructions before attachin...

Tap Splice with Crimp Terminal and Fuse 2 A, with holder. Can be used with Brodit active holders for fixed installation, e.g. holders with Molex adapter system, holders with speaker or Handsfree Ca...

Tilt swivel with face plate for AMPS. Can be angled 20° in every direction. A small, oval face plate with predrilled holes for Brodit holders and THB HF-kits. Can be angled 20° in every direction.

Mounting Accessorie

Extension mounting plate, angled 15°. With 6 predrilled holes. Used for angle the installed equipment and to get it further away from the dashboard. Angled 15°. Tha plate is 50x50 mm, thickness 18-...

A tool that makes installations easier, used e.g. to press into gaps in the interior in order to widen them. With thin ends, one pointy and one level end. Manufacutred in black ABS plastic.

Michrophone, 3,5 mm plug. 3 m cable. Michrophone for Handsfree Car Kit. 3,5 mm plug. 3 m cable. It is easy to attach the microphone to the Handsfree Car Kit, and then to attach it in the desired po...

Mounting plate, with tilt swivel. Attention! Read all instructions before attaching the holder. 1. Loosen the screw in the center of the holder so you can remove the attaching part on the back. 2. ...

Flexible arm, 15 cm. With predrilled AMPS-standard holes. A flexible arm with AMPS plates in both ends. For installation of monitors, printers and other heavier devices in busses, trucks etc. Is to...

Flexible arm, 25 cm. With predrilled AMPS-standard holes. A flexible arm with AMPS plates in both ends. For installation of monitors, printers and other heavier devices in busses, trucks etc. Is to...