Mounting Kits (4,566 items)

The extension plate makes it possible to attach to units onto the same ProClip, e.g. a PDA holder as well as a mobile phone holder. Comes with screws and adhesive tape on the back. With predrilled ...

MoveClip for Tilt swivel, with predrilled holes. 1 female + 1 male + 2 screws. 50 x 42 x 5 mm. The Move Clip system is basically a female plate with a wide V-slot and a male plate that is shaped to...

Female cigg-plug with open ends for fixed installation. Cigarette lighter socket with open ends for fixed installation. Is to be used when you want to use an active holder with cigarette lighter pl...

Vertical Mounting plate (155x50x5mm). The extension plate makes it possible to attach two devices onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder. With predrilled h...

Mounting plate (80x50x5mm). AMPS-standard. The choise when you want to install your device positioned a bit to the left or right than the center of the ProClip. Predrilled holes, AMPS standard. Mad...

Extension plate, 155x50x5mm. With predrilled AMPS holes. The extension plate makes it possible to attach two devices onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder...

The extension plate makes it possible to attach to units onto the same ProClip, e.g. a PDA holder as well as a mobile phone holder. Comes with screws, Size: 100x50x5mm

Mounting plate angle. 3-pack. Can be used for installation of two devices placed in different height on the same ProClip. (3pcs/pack).

Cover plate to be placed in compartment in the console to the left in Chevrolet Trans Sport 97- .

The device mounting adapter accommodates all devices/device cradles that have the AMPS hole pattern (a square like hole pattern) in the back of the device or cradle. The mounting adapter has a spri...

The device mounting adapter accommodates all devices/device cradles that have the AMPS hole pattern (a square like hole pattern) in the back of the device or cradle. The mounting adapter has a spri...

Plate with predrilled AMPS holes. 7x42x50 mm. Used for positioning the installed equipment further away from the dashboard. Dimensions: 7x42x50 mm.

Note-pad holder with tilt swivel. Holder for note pad, with tilt swivel. Attach onto ProClip Mounting Platform. (Note pad and pen are not included.) Attention! Read all instructions before attachin...

Fuse 2 A, with holder. Can be used with Brodit active holders for fixed installation, e.g. holders with Molex adapter system, holders with speaker or Handsfree Car Kit.

Tilt swivel with face plate for AMPS. Can be angled 20° in every direction. A small, oval face plate with predrilled holes for Brodit holders and THB HF-kits. Can be angled 20° in every direction.